Christmas Ornaments & Display Stand
Mike Brazeau
>This set of six ornaments and stand are for a silent auction at our annual Force Gala this weekend. (See www.stopthequarry.ca ) My wife and I were in Len�s Mill Store, Port Dover, ON on Labour Day weekend and I saw these brass plated rings which I found out later are used for Macram� work. Wheels started turning (NPI) and by last week I had gone through three ideas of mounting and my last one was the easiest and seemed to work out well. I picked up a couple of the rings while on a work bee at the cottage last week. Bell (with Ebony Clapper) and Angel (thank you Eugen Schlaak for design) are plain Box Elder (Canadian Holly) I processed a couple of years ago from fresh log pieces. I hollowed both with my homemade Hunter/Eliminator tool. By using Cellulose Sanding Sealer on the Box Elder, it stays very white. Other woods used are some 40 year old Pennsylvania walnut (gift of a fellow turner from Baltimore), Ebony, Mulberry Birdhouse Roof, Spalted Maple and Box Elder ornament ovals and a Sea Urchin as well. Ring is 8� in diameter. Stand is 6 �� in diameter and 13� high, with beads on base by Triple Point Tool and texturing with Sorby Texturing Tool. Ornaments finished with Cellulose Sanding Sealer and Myland�s Quick Build. I did put Watco Danish Oil on the Walnut to pop the grain, before a light coat of Myland�s. Any comments welcome of course.



