How do you remove.....
Ray Carson - Lawrenceville, NJ
>Hello,
How do you remove the little digs that are caused by a four jaw chuck? What are some recommendations? Of course, I could just sand down the tenon / foot and all is a matter of choice and opinion. What's yours? The sketch I sent is only for discussion purposes. The foot is only about 2 1/2" across. I cannot reverse the bowl on the lathe as I do not have any chucks, jaws or lathe tools that will allow me to do this. I suppose I could make something like a jam chuck but I'm ascared of ruining the bowl if it isn't built right. Ignore the cross hair from ACAD.
Thanks,
Ray



