Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

Nova G3 Chuck Problem - Anyone Else?

Posts

Nova G3 Chuck Problem - Anyone Else?

#1

Nova G3 Chuck Problem - Anyone Else?

Mike in Shreveport/Bossier City, LA

>I just got my new Nova G3 chuck from CS-USA and the runout on it is absolutely horrible! You can actually see the wobble in it on the slower speeds (must be 1/16 to 1/8 of an inch of wobble). Has anyone else had this problem? I'm just wondering if I should send it back and save my pennies for a Vicmarc or Oneway chuck if this is a recurring problem with the Novas, or if I should just exchane it. Any advice?

Thanks,

Mike

Re: Nova G3 Chuck Problem - Anyone Else?

#2

Bill Blasic

Re: Nova G3 Chuck Problem - Anyone Else?

Bill Blasic

>More info may help, what kind of lathe? Is the chuck fully seated? How about the insert, is it a true Nova insert? I currently have 3 G3's that run less than .002. I believe That Teknatool specs say that they run with in .005 or .006. I've heard problems of late with different chucks and lathes that do not allow the chuck to seat properly.

Re: Nova G3 Chuck Problem - Anyone Else?

#3

Re: Nova G3 Chuck Problem - Anyone Else?

ken

>I also have it and it has almost zero runout.I heard that there are some aftermarket inserts out there that have give folks a lot of trouble.If that is true,you may have one of those.

Re: Nova G3 Chuck Problem - Anyone Else?

#4

Re: Nova G3 Chuck Problem - Anyone Else?

Steven Kubien

>There was a problem with knock-off Teknatool inserts floating around. I would contact them and see, although I doubt CSUSA had them. You never know.

Steve

Re: Nova G3 Chuck Problem - Anyone Else?

#5

Re: Nova G3 Chuck Problem - Anyone Else?

Mike in Shreveport/Bossier City, LA

>The lathe is a Nova DVR and the insert came in a Nova box. I probably just got a bad one (if there's one in the batch you can guarentee with my luck that I'll get it). I double checked how it was seated (both the chuck to the lathe and the insert to the chuck). I'll see if anything different pops up before tomorrow and if not, I'll just get a replacement then. Thanks for the info.

Mike

Re: Nova G3 Chuck Problem - Anyone Else?

#6

Also had a bad insert that caused terrible runout

Don in Northern Arizona

>I bought a 1 1/4 X 8 insert that had terrible runout. I have replaced with an L insert (bigger one with the set screw) from Craft Supplies and it has no visible runout.

Don

Re: Nova G3 Chuck Problem - Anyone Else?

#7

Re: Nova G3 Chuck Problem - Anyone Else?

Ed in Sptbg.

>I have several Nova chucks and have had run-out problems with a couple of them. The shoulder on the end of the adapter should fit into and bottom out in the chuck body. Clean up any burrs and ridges on that shoulder and down in the chuck body. That will usually take care of the problem if the adapter is a good one and is seated properly.