Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

Electric motor find

Posts

Electric motor find

#1

jim miles

Electric motor find

Jim Miles

>I was given a Craftsman lathe recently without a motor. Went by local Goodwill, spotted a treadmill for $30. Clerk could not get it to run and offered to sell it to me for $15. So I decided to take a $15 chance. I figured it it wasn't any good I could always donate it back to Goodwill. Got it home, found out it took a special safety key to start the treadmill, that was missing, so the clerk could not start it. The motor ran fine. It was an almost new A O Smith motor 1 horse, 1725rpm ( unfortunately not reversible )

with a variable speed drive system. Don't know if I can get variable drive to adapt to lathe ( Anybody know about this ? ) But not a bad motor for $15.

Re: Electric motor find

#2

Re: Electric motor find

Don Evans

>Jim:

Why don't you just move the electronic's package from the treadmill with the motor and mount it so it can run the motor on the lathe?

That is what others have done with this type setup. I have a treadmill motor with it's electronics that I use for honing carving tools and any other hand held cutting tool or blade. Never have to grind on these with this setup, just keep honing.

I think you will find that this motor isn't really a true 1 hp as others have found with tread motors. In the real world it is more likely equal to 1/2 hp, but that's ok the conversion process is a good teacher for different things, consider it a learning process.

Does the controller portion have a dial that turns or a down and up arrow buttons for speed control? If dial then board can be removed and installed in what is called a project box from somewhere like Radio Shack (plastic box), if arrows then you have slight problem to over come requiring moving the cover plate with the board and mounting it.

Don

Re: Electric motor find

#3

Re: Electric motor find

Bill Howatt

>I think if you do a Google search for something like: treadmill motor lathe you will get lots of info.

I believe the motors are usually DC motors and, if so, can be reversed by "reversing" the wires at the motor with a DPDT switch.I am assuming there are no mechanical considerations that would make this a bad idea.

Bill