Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Clockwise turners?

Posts

Clockwise turners?

#1

Roger Dunn

Clockwise turners?

Roger Dunn

>After going through the financial gymnastics of shelling out a lot of money for a new lathe, it kinda' hit me. I have an unused outboard attachment for my 4224 with the same spindle size as the headstock. For fear of watching the work unscrew, I thought to myself, why not turn clockwise and save a lot of money. Is it hard to relearn to turn outboard and in the center of the bowl which started this exercise in the first place?

Do many others turn outboard clockwise?

Thanks again

Roger Dunn

Re: Clockwise turners?

#2

Keith Tompkins

Re: Clockwise turners?

keith tompkins

>Hey Roger, Isn't the outboard spindle left handed thread? If not, it should have a groove for a set-screw. That way, you can turn in the usual way. I turn outboard occasionally, the General has L/H threads.

Re: Clockwise turners?

#3

Re: Clockwise turners?

Wally Dickerman in Arizona

>Oh Yeah....been turning as a lefty for many years. First, on the outboard side of a Delta in the seventies, Same thing on a General 260 in the eighties and early 90's. Then on a custom lefty lathe by Nichols, and now on the outboard side of my Oneway 2016.

But then, I am left handed. Not until I started turning hollow forms did I need to hollow them left handed.

When I teach and when I do demos I have to do HF's as a righty. Just stand off to the side a bit and you'll get used to it.

Wally

Re: Clockwise turners?

#4

Re: Clockwise turners?

Bernie

>If you are right handed and your lathe will run in reverse

you can outboard turn as if you were between centers.

Good Luck

PS that is the only way I turn

Bernie

Re: Clockwise turners?

#5

Roger Dunn

Re: Clockwise turners?

Roger Dunn

>Thanks all for your comments. The Powermatic has right hand threads hence my concern about unscrewing so I am going to try clockwise on the outboard and see how that goes.

Re: Clockwise turners?

#6

Just cinch up the chuck/faceplate real tight

James McClure

>