Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Price drop on over 1300 Rockler items

Damaged Lathe

Posts

Damaged Lathe

#1

Damaged Lathe

Ned Bulken

>I moved my lathe into the shop last night. In the process of doing that, somewhere this weekend, it must have gotten dropped on the left rear corner. NOw I only have three points to bolt it down, but that should be enough to keep things stable. If worse comes to worst, I can always drill a hole in the side of the casting, and bolt it to a board which I would then lag bolt to the stand or bench (depending on which I decide to use). It's only a midi, so I won't be spinning anything Too huge after all.


img

Re: Damaged Lathe

#2

Re: Damaged Lathe

Sean Troy

>Just use some JB Weld to put it together again. Works great.

Re: Damaged Lathe

#3

Re: Damaged Lathe

Don Orr

>Sorry to see that Ned, hope that is all that is damaged. I haven't done my rounds of the forums for a few days, but it looks like things are moving along nicely. Tools in the shop is GOOOOOD !

Re: Damaged Lathe

#4

Ditto

Ron in Drums PA

>

Re: Damaged Lathe

#5

Steven Antonucci

I have had luck with CA glue

steve antonucci

>Believe it or not. If you don't have JB Weld, cost you nothing to try it...

Steve

Re: Damaged Lathe

#6

Re: Damaged Lathe

Galen V

>Picture looks like you have at least half the mounting lug hole left. I would not try to drill another hole. Just put the broken piece (or filler if broken piece is lost or in multiple pieces) in when you bolt it down to keep the bolt vertical. With a four bolt mount you should not have enough lateral movement that the half mount will not hold.

Re: Damaged Lathe

#7

Re: Damaged Lathe

Jim Shaver - Oakville, Ont

>Hi,

Braze on a new piece of metal and redrill, then grind the edge to shape.

Take it easy,

Jim

Re: Damaged Lathe

#8

Re: Tools in the Shop

Ned Bulken

>Don,

just to make it official: I've formally jumped into the abyss. It wasn't the first tool in the shop, but it won't be leaving any time soon...

check your email :)


img

Re: Damaged Lathe

#9

Re: Damaged Lathe

sAM sCALZO

>NED

I have mine bolted with just two bolts. One at opposite corners. Works just fine. SAM