Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

blown vessel

Posts

blown vessel

#1

blown vessel

john lucas

>I haven't been able to turn much this week. I started on this earlier in the week and apparently should have measured the inside more closely before working on the final stages of the outside. I usually do the outside first and then the inside. Oh well, another day another dollar lost. I don't know what this wood is but it's the hardest wood I've ever turned. It was a small piece given to me by Ed Lewis.


img

Re: blown vessel

#2

Re: blown vessel

Marvin Ewing

>Looks familiar. I've worked on a piece for hours and go through the side. Better luck next time.

Re: blown vessel

#3

Re: blown vessel

John K Jordan

>Could it be lyptus? Hardest wood I've ever turned.

Re: blown vessel

#4

Re: blown vessel

Texian

>Aw, gosh darn, shucks. Hate when that happens.

Re: blown vessel

#5

Re: blown vessel

Ian

>john, I got a piece of walnut that looks like that sitting on my bench. somehow the the inside got bigger than the outside. :-)

IAN

Re: blown vessel

#6

Steven Antonucci

I feel your pain

steve antonucci

>I have done that more often than I can even recount. In fact, I did it last week on this vessel. I measured it, but it's really hard to get an accurate measurement at the bottom of something 14" deep when you have 1/4" as a goal.

The sides at the top are 1/4", and as I got to the bottom, probably more like 3/8". I assumed I still had at least an inch of wood at the transition point, but found out I was way off when I cut through the bottom and it was spinning around my boring bar.

The good news is that I had planned to do something with this one that didn't rely on the wood being perfect, so I decided to put Humpty Dumpty back together again. I started with a little epoxy to get the wood reconnected at 3 points, and then slowly filled in the 1/4" gap with epoxy and shavings. Sanding in between layers (like automotive body work)...

Might be an opportunity to try a new process?

Steve


img

Re: blown vessel

#7

Steven Antonucci

The bottom 

steve antonucci

>


img

Re: blown vessel

#8

Re: blown vessel

Barry Turner

>you didn't go through the side.......you just ran out of wood. :-)