Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Turning Antler

Posts

Turning Antler

#1

Turning Antler

JB-Phx

>I'm looking for some information on turning antler. My brother has sent me some nice pieces of anler that he found and he would like me to make him a pen. Does anyone have any first hand experience with turing this material and maybe a few hits and/or cautions?

Re: Turning Antler

#2

Re: Turning Antler

Ken Oakley-Sunny St. Cloud, Fla.

>I haven't turnrd any buy have cut and sanded a batch for a friend. It stinks. Literally. Smells like burning hair. I hold my breath when machining it.

Machines OK but is somewhat porous.

Re: Turning Antler

#3

Re: Woodturning Design

Steve in NC

>Check the Woodturning Design Index. They had an article a while back.

Steve

Re: Turning Antler

#4

Re: Turning Antler

Scott Greaves in Blackfoot Idaho

>Hi JB,

Antler makes a nice pen! I like to cut the sections of antler a little longer than needed, then mount it to the lathe between centers and turn it so it's at least somewhat more symmetrical. This makes it easier to drill, and the turning process later is speeded up by not having to take off the odd protrusions. The center of antler is kind of like a hard sponge, so I like to use polyurethane glue to glue the brass tubes in because it expands into the porous material better - just my preference. If in the process of turning the pen you cut down through the outer layer of the antler so that some of the porous stuff shows, sand with some CA glue to act as a sealer.

This is like the cliff-notes version of how to do this. There are some really nice articles on working with antler over at the IAP. Good luck! And have fun with this nice material!

Scott.