Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

natural bowl

Posts

natural bowl

#1

natural bowl

ILYA Zavorin

>Recently I came across an interesting piece of wood that has a shape of a bowl. I am wondering if I can turn the outside as smooth as I can and leave the inside as is. The main issue is that this piece has been under the elements for a long time and may be rotten. I was thinking of cutting the bottom off to put a faceplate on it, but I am not sure whether the faceplate will hold. Is there a way of stabilizing/hardening the wood other than soaking the whole thing in a pool of CA glue?


img

Re: natural bowl

#2

Lyle Jamieson

Re: natural bowl

Lyle Jamieson

>There are many ways to mount questionable wood. If it were me, I would put it between centers. Use a balance point not a geographical center point for holding between centers. Now you are under control and can get the lathe speed up to do some information gathering. Clean off a spot and make the surface slightly concave for the largest faceplate you can get on it and make sure you have loads of screw holes in the faceplate. The faceplate will then have a good seat around the largest diameter. I dont ever try screw a faceplate on a chainsaw cut. I would never use a chuck either. Now you can evaluate wheather you want to take the risk of turning it or discard it as a bad idea. Be careful you could get hurt. Remember JJ's famous quote, "Life is too short to use S**tty wood" Someone recently cleaned up the quote to read "crappy wood" but I think the original is correct.

If you still want to proceed a way to hold a questionable hunk of wood would be to drill holes into the wood about 3/4 inch away from the faceplate, and parallel to the faceplate. I use 3/8 drill and then fill the hole with a 3/8 inch dowel. Drill the holes so that every screw intersects the hole and dowel. The dowel is cross grained to the screw and will give you a very secure grip.

Re: natural bowl

#3

Re: natural bowl

GaryG in MD

>Very interesting piece.

Lyle gave you some very good advice.

If the piece seems to be fairly solid and safe, but needs some hardening to make good cuts, you could soak it with a can of Zinsser's clear shellac, or a bottle of PC Wood Petrifier (available at Strosnider's).

The former will do some yellowing; the latter doesn't.

I hope it works out for you. ...Gary

Re: natural bowl

#4

Re: natural bowl

john lucas

>I agree with Lyle. Put it between centers and do some excavating to see what conditions you have. You might get lucky and hit solid wood so you can use a chuck or faceplate. Lyle's method of putting dowels crosswise through the tenon works great. I've tried it. Don't know who I learned that from but it does work. I use thinned lacquer to stabilize punky wood. It makes it so you can cut it but won't make it touch enough to make a tenon for a chuck.