Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

help General won;t start

Posts

help General won;t start

#1

help General won;t start

Hugh Widdup

>I have a General 260 with variable spend control. I had a large bowl blank on and was bringing it up to speed/wobble control and the lathe cut out. Now it will not run at all. is there a reset i have missed?

there is power at the wall plug.

any help would be appreciated

Hugh

Re: help General won;t start

#2

I'll be right there, I'll bring my pipe wrench!

Ruth Niles

>Not to worry, I'm not really coming over. I have a General 260 but have never had it just cut out. Do you have the CD that came with it, there might be something on it that tells you what to do. Or the instruction manual on those extra 2 pages about the electric box on the back of the lathe.

You can always call Christian up in Canada, he's a sweetheart and a big help. He stayed on the phone with me for an hour walking me through replacing a reeves drive on my old General.

Re: help General won;t start

#3

Re: I'll be right there, I'll bring my pipe wrench

Hugh Widdup

>and a hammer.

I will probably give them a call in the morning.

I am not sure where the manual is either :(

instrutions who needs them :}

Re: help General won;t start

#4

Keith Tompkins

Re: help General won;t start

Keith Tompkins

>Hugh, Simply disconnect the power supply at the wall plug, and wait one minute. This allows the inverter to reset. If not, codes are flashed on the converter after reconnecting to power. Be sure you didn't accidentally move the rev/forward switch to the center.

Re: help General won;t start

#5

Thanks Keith

Hugh Widdup

>That was it!

Thanks again

Hugh

Re: help General won;t start

#6

Re: Thanks Keith........me, too, Keith!

Ruth Niles

>That was something I'll have to remember, which shouldn't be too difficult, just think of the lathe as your computer, turn it off to turn it on. : )