Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

measuring thickness of large urn

Posts

measuring thickness of large urn

#1

measuring thickness of large urn

Mike Nelson

>I am turning a large pot/urn about 14X16 and using my largest homemade calipers don't get a true measure at top or near bottom, only at the center. Any tricks out there that don't involve expensive lasers etc.???


img

Re: measuring thickness of large urn

#2

Steven Antonucci

Ellsworth calipers

steve antonucci

>Bent wire used as a feeler. Bend a section of wire (armature wire, coat hanger- just something stiff) until it is an C shape. The distance between the two ends of the C is your reference. If it is an inch, and you insert it to a point on the vessel and see 1/2" outside while you can feel the inside touching, you have a 1/2" wall.

For the bottom, I use the same technique, but there is a d shape to the caliper. The straight part of the d is two pieces of rod in parallel. The one piece of straight rod goes inside the vessel to the bottom and the curved section is outside. When the caliper is closed, both ends of the parallel rods are the same length at the top. When inside, they are different by the thickness of the bottom and measured at the end by the difference.

I couldn't find a picture, and I think I scavenged the steel for another project. Hope the description isn't too cryptic...

Steven

Re: measuring thickness of large urn

#3

Re: Ellsworth calipers

Mike Nelson

>Thanks Steve, I knew I heard something about stiff wire, not sure what you mean about the bottom but this should help me with the top. I want to get this piece of Maple to about 1/2".

Re: measuring thickness of large urn

#4

Steven Antonucci

Quick and dirty drawing

steve antonucci

>When you "close" these, the two rods touch at the top and the bottoms are even. Mine is two pieces. Works well.

S


img

Re: measuring thickness of large urn

#5

ebd

Re: measuring thickness of large urn *LINK*

ebd

>Take a look here:


Link to how to make

Re: measuring thickness of large urn

#6

Steven Antonucci

I knew I had seen it here first!

steve antonucci

>Thanks for reposting this. Mine is nowhere near as pretty as yours is, but I might just have to make another one. I don't make the leg on the bent section as long as yours is, and I turned a small button on the back of the straight rod to have something to grab onto.

Steven

Re: measuring thickness of large urn

#7

jim miles

Re: measuring thickness of large urn

Jim Miles

>Another method: drill hole through side wall of vessel with the smallest bit you have. Stick wire through - get good reading of thickness. Fill hole when done, if highly figured wood, you'll never see hole.

Re: measuring thickness of large urn

#8

Re: measuring thickness of large urn

Mike Nelson

>Thanks! I knew there was a easy way, just couldn't remember!