Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Orca Lathe

Posts

Orca Lathe

#1

Orca Lathe

Jim Shewan

>Picked up an Orca lathe on trade me (NZ auction site) a couple of months ago after some positive feedback from message boards and just thought I would share my first impressions of it.

I started turning on a cheap NZ made lathe I was given and then almost immediatly saw an almost new VB36 on trade me and soon had it in the shed. I can't praise the 36 enough but the Orca has some advantages for some things. I like the lightness and ease of setting up and tuning very small stuff is just so relaxing. The chips just make a small pile round the lathe and catches are a complete non-event so I've learnt a lot about correct tool usage.

The VB is wonderfull for large work but after a day a day attacking a big peice of Rata ( Metrosideros robusta)you know you've been working. Catchs can be downright frightening and if I start a new project there is generally hours of work ahead.

By contrast I stick a little iddy biddy peice of wood on the orca and can have it pretty much finnished in 20min and then just hang the lathe on the wall and sweep up a couple of handfulls of chips.

You can do small stuff on a big lathe but just starting and stopping that massive shaft takes time and power with a top speed of only 2600. Its horses for courses and two lathes are better than one.

Re: Orca Lathe

#2

Re: Orca Lathe

E. Tabachek

>Hi Jim, That is quite a shift; Orca to VB36 and back again. I am glad to hear that you are enjoying the "Little Blue Monster". There are many useful projects that can be made on these little lathes that will give the turner hours of fun. It is summer here in Canada so I like to carry mine outside and turn on the patio, if the people bitting bugs are not too bad

For those who are not familiar, the Orca is a Bonnie Klein knockoff that was made by a guy in British Columbia, Canada. He had links to New Zealand so perhaps he shipped some of these lathes there. ET

Re: Orca Lathe

#3

Re: Orca Lathe

Bill Crommett

>Jim : Does that mean you are a COLLECTOR of lathes with the addition of the Orca and the BIG IRON ? Are you going to stop at Four ?

Re: Orca Lathe

#4

Re: Orca Lathe

Jim Shewan

>Well Bill I suppose I should come clean and admit to everyone that I have recently gone over to the "DARK SIDE" with the latest aquisition to my workshop.

The pic tells the sordid tale.


img

Re: Orca Lathe

#5

What IS That ???

E.T.

>That is not a VB36 nor is it an Orca. Are going big and bigger? ET

Re: Orca Lathe

#6

Looks like a railway car!

Steven Kubien

>It also looks like a lot of fun.

Re: Orca Lathe

#7

Re: What IS That ???

Jim Shewan

>This is a South Bend long bed metal lathe manufactured pre1947.

Took me nearly all day to get it in the shed, steel must have been cheap when this was made cause they sure used plenty. Its got a few miles on the clock but I'm sure it'll see me out.