Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Turn barefoot. Problem solved.

Posts

Turn barefoot. Problem solved.

#1

Steven Antonucci

Turn barefoot. Problem solved.

steve antonucci

>I've done it before, and there's something satisfying about standing on the "fresh bedding". Cool and comfy. Don't recommend it for splintery woods like oak though- especially if you don't want "black feet"!

I wear boat shoes most of the time. They're so ratty, they're not allowed in the house. They fit tightly, provide some protection, and don't seem to fill up. Most of the time, my left foot is forward, so I'll have to watch to see which shoe gets the chips now...

Steven

Re: Turn barefoot. Problem solved.

#2

Steven Antonucci

Answer to John's problem below...

steve antonucci

>

Re: Turn barefoot. Problem solved.

#3

Re: Turn barefoot. Problem solved.

john lucas

>I've turned barefoot. I like it. I don't turn big stuff, for obvious reasons. I like it when it's not to hot outside and I can open the garage doors. It almost feels like I'm outside especially when standing barefoot in the shavings. After all I grew up in Kentucky and we didn't wear shoes until I was 13. :)

Re: Turn barefoot. Problem solved.

#4

Re: Turn barefoot. Problem solved.

Mike Jones, Redding, CA

>I work in my shop barefoot about half the year round. I used to ski "bare" once in a while, but that's been many rears ago. I've been thinking about turning some big-ash bowls nekked too. The only reason that I haven't so far is the age thing. (by the time I'd get into the shop I'd forget.) How about you?

Re: Turn barefoot. Problem solved.

#5

Re: Turn barefoot. Problem solved.

Woody in VT

>You don't end up with shavings in unusal places turning nekked?

Re: Turn barefoot. Problem solved.

#6

Re: Turn barefoot. Problem solved.

keith zimmerman, Normal IL

>I always turn barefoot at home. Of course, my "monster" shop is located only about 3 feet from my bedroom and is even closer the bathroom and kitchen.

There are advantages to turning in a walk-in closet. Not many, but this proves there is at least one.

keithz

Re: Turn barefoot. Problem solved.

#7

Re: Turn barefoot. Problem solved.

Bill Grumbine (Kutztown PA)

>Sounds great until you drop your skew.

Re: Turn barefoot. Problem solved.

#8

Re: Turn barefoot. Problem solved.

john lucas

>Bill I dropped my skew with my shoes on. Stuck through the shoe and into the arch of my foot. I think I said "oh you sweet skew" or something to that affect. I now lay it down very carefully on the lathe bed when I'm done.

Re: Turn barefoot. Problem solved.

#9

Steven Antonucci

Whole new meaning to "I had a big catch!"

steve antonucci

>

Re: Turn barefoot. Problem solved.

#10

You are too generous!! NM

Mike Jones, Redding, CA

>

Re: Turn barefoot. Problem solved.

#11

Did that with a chisel.... now it's leather shoes

Brian Hahn in SW Wisconsin

>