Learning new skills.
john lucas
>You never know where woodturning will lead you. I'm doing 16 5 1/2"x 13" spindles for a gentleman and they need square bottoms. My Bandsaw will only cut up to 12", my miter saw 4 1/2", and my skill saw about 3". The chain saw chips the corners to that's out. Fortunately I built a bowl saw quite a few years ago and it's been sitting. It will just barely cut that deep however it wanders off line pretty badly. I can clean up the edge on the bandsaw which is fortunate because it has to be square. Obviously the bow saw blade needs sharpening and resetting.
Here's where the learning part comes in. I've been wanting to learn to sharpen handsaws and even bought the setting tool. Today is the day. I'm re-reading Leanard Lee's book on sharpening during lunch and will go to it after I finish my bike ride. Then I just need to turn 10 more of those spindles but at least cutting the blanks will go easier.



