Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Cast Iron Radiator Handles

Posts

Cast Iron Radiator Handles

#1

Cast Iron Radiator Handles

RiccoG

>Hi A neighbor stopped me tonite and showed me a handle off a cast iron radiator about 3 to 3 1/2 ins. in dia. and about 3/4" thick with a square hole in it to fit over valve. It looks like a wood wheel off a toy truck. Any help or tips and what wood to use.

Thanks Rick

Re: Cast Iron Radiator Handles

#2

Re: Cast Iron Radiator Handles

Rick Allen

>I would use something hard. Brazilian Cherry comes to mind as a good choice.

If you can put an insert in to take the wear of the square fit then many other woods start to look like good options.

You could make the insert out of Brazilian Cherry. I would make the insert square. So a piece of Brazilian Cherry that is 1 1/2" square with a 3/4" square hole in the middle for fitting over the radiator valve. If the insert is going to show through the "wheel" wood you might want to have the "squares" 45 degrees out of sync just for looks.

A ball or dome shaped "wheel" might be nice. Drill some 3/8" holes around the "wheel" and fill the holes with a contrasting wood could give a nice effect.

Sounds like a fun project.

Re: Cast Iron Radiator Handles

#3

Re: Cast Iron Radiator Handles

don lewonczyk

>I haven't used any wood around a heat source but I would think white oak or teak maybe rock maple would work. Persimmon may also be a good choice, im not that familar with the exotics to say much about them and im sure you will get more answers to your question. Luck, DonL

Re: Cast Iron Radiator Handles

#4

Re: Cast Iron Radiator Handles

eaglesc

>Lignum vitae?