Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

If it don't feel right...STOP!

Posts

If it don't feel right...STOP!

#1

If it don't feel right...STOP!

Ron McKinley

>I was in a hurry to finish turn a bowl so I could give it to a friend two days hence. I mounted it and trued up the tenon, mounted it in the chuck and realized my bowl gouge needed sharpening. I stuck it in the Vari-Grind, set the nose angle and then noticed that I had to adjust the arm out siginificantly. That was my first clue, but, being in a hurry I pressed on. I really felt uncomfortable because the gouge was too close to the center line of the wheel. Then WHAM! My Vari-Grind and Thompson bowl gouge were bouncing on the floor and I was jumping out of the way and noticed blood all over the floor.

Went inside and washed the wound with hydrogen peroxide, dried it, grabbed a Band-Aid and went back to the shop and dripped a little CA on the cut, wrapped it tightly with the Band-Aid and at that point my pride hurt more than my finger. Picked up the Vari-Grind/gouge and remembered my friend and handyman had been in my shop borrowing tools earlier and had picked up the Vari-Grind and asked what it was. I told him, but I was not paying a lot of attention, he apparently re-set the angle, laid it down and walked out.

The grinding wheel has a big chunk out of the side near the edge but the Thompson bowl gouge came through pretty much unscathed. I'll just have to re-grind it.

The moral of this story is: If it don't feel right and it don't look right, STOP! Haste makes waste and I wasted a grinding wheel, a little flesh and a lot of pride! ......Ron

Re: If it don't feel right...STOP!

#2

Re: If it don't feel right...STOP!

Sean Troy

>Man, have I found that out the hard way before !!

Re: If it don't feel right...STOP!

#3

Re: If it don't feel right...STOP!

Tommy Holmes

>I've got a chunk missing of the side of my wheel too. I had the same feeling that something wasn't quite right either.......but didn't listen.

Re: If it don't feel right...STOP!

#4

Re: If it don't feel right...STOP!

E.T.

>Could someone try to explain what kind of angle the vari-grind was set to. My turning buddy says there is a potential for the tool to jam into the wheel, withe disasterous results using the V-G and I said I don't think so. ET

Re: If it don't feel right...STOP!

#5

Re: If it don't feel right...STOP!

Jim Pugh, Elyria, OH

>The angle of the VG isn't what's so important. You MUST keep the tip of the tool above center on the wheel or bad things will happen. DAMHIK.

Re: If it don't feel right...STOP!

#6

Re: If it don't feel right...STOP!

Donna Banfield

>If your tool slips in the jig, it will be one of two things: you haven't tightened the screw/handle down to clamp the shaft in it, or worse, the flexible thin metal strip has become too smooth on the surface, causing the tool to slip with just the slightest pressure --like the tool tip meeting the grinding wheel.

In either of those events, when the tool slips, the forward motion of the grinding wheel will push the tool down, and slam it into the V-arm.

This has happened to me, and I've seen it happen to others.