Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

10 Chalices #1

Posts

10 Chalices #1

#1

10 Chalices #1

Steve in NC

>Each year our church holds a service that honors the young adults that are graduating from high school. As part of the service each graduate is given a gift to conect them to the congregation. This year, I was asked if I would make a flaming chalice (a symbol of gathering and community in our church) for each of the graduates. The attached photo is a result of the ten chalices I made. They are typically 6-8 inches in diameter and about 4 inches high. The second post shows a detail of one of them.

This was great fun and the response was most appreciated.

Comments welcome.

Steve


img

Re: 10 Chalices #1

#2

JL

Re: They look good...

JL

>votive cup inserts? Did you use a Forstner bit to cut the holes?

Re: 10 Chalices #1

#3

Re: They look good...

Steve in NC

>The votive cup inserts are tapered on the bottom so I just cut a cone shaped recess with a gouge using some trial and error. I sometimes make these with the oil lamp inserts but since these were for teens I thought the tea lights would be better. I did however put a dab of Goop to hold the inserts in.

Re: 10 Chalices #1

#4

Re: 10 Chalices #1

Mark H

>Nice thought Steve and nicely turned.

Mark