Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Anyone using automotive clear coats?

Posts

Anyone using automotive clear coats?

#1

Anyone using automotive clear coats?

Steve Worcester

>I have recently started using automotive clear coats instead of wood working pre-cat lacquer, big learning curve.

I am using House of Kolor UFC35 with all the reducers and catalysts but still getting solvent pop. would be interested in hearing from others using non-pre cat clears and suggestions.

The finish is flowing beautiful, just little pinholes. With pre-cat lacquer, using Hood low-voc, I got good results, but looking for something harder, clearer I am working with the new stuff. Real suseptable to humidity in the lines (not RH in the air). Any suggestions would be appreciated.

Steve Worcester

www.turningwood.com

send beer

Re: Anyone using automotive clear coats?

#2

Re: Anyone using automotive clear coats?

Lan Brady

>Steve,

I am a rookie at using auto lacquer. I noticed the same thing though. For me, it was 2 sources. The first one, the auto lacquer was so clear that I was being more critical.

Second , I was spraying too dry. I reduced the pressure to where it just barely siphoned without interuption to the stream. Then I sprayed a wet edge. The problem went away.

I hope a more experienced person gives you some valid advice.

Good Luck, Lan

Re: Anyone using automotive clear coats?

#3

Re: Anyone using automotive clear coats? *LINK*

Mark Wollschlager

>You might check with Kim Blatt.

He uses some fancy spray stuff, his web site says acrylic lacquer,

but I thought he told me that it was a pre catalyzed polyurethane.


Kim Blatt woodturning

Re: Anyone using automotive clear coats?

#4

Ric Taylor

Re: Anyone using automotive clear coats?

Ric Taylor

>Steve,

This may not work directly in your application, but it might give you some ideas. On my airbrush, I have installed a cheap automotive fuel filter in the air line, close to the airbrush end of the air line, away from the compressor. It traps all of the moisture that gets past the moisture trap of the compressor. The filter is the type that is just a clear plastic bulb, with a paper cartridge in it.

I hope this helps.

Ric

Re: Anyone using automotive clear coats?

#5

Re: Anyone using automotive clear coats?

Mike Jones, Redding, CA

>I finished one piece with auto clear coat and could see the value in continuing to learn it's use. I found it not nearly as easy to build up as is clear lacquer and so I quit. I'll be interested in your reports as you work with it.

Re: Anyone using automotive clear coats?

#6

Re: Anyone using automotive clear coats?

Steve Worcester

>I am using House of Kolor UFC35, which is a urethane and HOK (as the kids call it;) is reputedly more difficult to work with.

I think it is more susceptible to water and humidity in the air lines, far more than wood lacquers. I think it builds at least equally as well, and it can be color sanded and buffed the next day, which was one of the most appealing features. It is 3 part, product, reducer and catalyst. Haven't gotten it to flow like a wood lacquer yet, which is where my quest heads in the shop today. When the glass, airbrush and new clears learning curves get out of the way, I may get to turn some more wood

Steve Worcester

www.turningwood.com