Re: Wolverine Grinding Jig Instructions
Don Evans
>If their instructions have NOT changed since day one, then the first you stated sounds right. I only say it like that because of the difficulty of terminology used.
Setting the 6.25 to 6.5 using the top of the V is NOT correct.
The measurement should be made from the bottom of the assembly that the "V" arm rides in, up to the center axle of the grinding wheels.
I made mine using a cast iron grinder stand with a wooden laminated top, the top being mounted UNDER the small top of the cast iron stand, this made everything much easier to mount the wolverine as a 2x4 laid on it's side (1 1/2" thick) was a perfect shim for the "V" arm base to sit one. Measurement came out exactly half way between 6.25 and 6.5".
This stand sets on the base of my old Delta dust collector and is sucking air through both sides of it and blowing outdoors. NO, the bags are NOT on it for obvious reasons, only pipe from grinder to outside. On the end of the outside pipe is a special plastic (heavy duty) cloths dryer vent which I liked so much I put one on the house for the dryer. This is the one that has the can looking device on top of the hose that lifts up when air is moving and comes back down when turned off so pipe is sealed against insects rodents etc. I paid $50.00 for each then found same exact one for $20.00 this sites normal price, isn't it always the way? If you're interested in the vent, go to http://www.sportys.com, it's item number 3985T, sometimes you have to call them as the numbers cannot be found searching. I've ordered couple of times from them and no prolems so far. I have NO affiliation with these folks in anyway other than custormer.
Anyone want a snap shot of grinder set up let me know and I'll put one or two on here.
Don