Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

P&N Tools

Posts

P&N Tools

#1

P&N Tools

Steven Smith

>I just purchased a P & N 5/8 bowl gouge. After I turn and drill a handle, do I need to set the gouge in CA glue, epoxy or just a tight fit? Thanks in advance.

Re: P&N Tools

#2

Re: P&N Tools

Doug Thompson near Cleveland

>Steven, use what is available (CA or epoxy) you'll find it doesn't take much to hold them in place.

Re: P&N Tools

#3

Re: P&N Tools

robo hippy

>I have never glued one in yet. I do make the ferrule fit tightly though. No problems with them coming loose.

robo hippy

Re: P&N Tools

#4

Re: P&N Tools

Bill Neddow

>Steven, I have taken apart dozens of commercially-handled tools over the years and have never seen any evidence of glue being used by any company. All you need is a tight fit.

Re: P&N Tools

#5

Re: P&N Tools

Mike Brazeau

>Steven - I have three of these and have found them good value, but if I can ever wear them out am going to be in touch with Doug. I have found however that hey are metric sized and if you drill to the English drill size, they are quite loose fitting, so I have been using 5 minute epoxy to seat.

Mike

Re: P&N Tools

#6

Mike Stafford

Ditto what Mike said...

Mike Stafford

>I found I had to drill the tang holes with a metric drill as well to get a nice tight fit.

Re: P&N Tools

#7

Re: P&N Tools

Brian Hahn in SW Wisconsin

>I use a tight fit, as in hammer-it-on tight. I've never had one come loose. When I changed a few handles, I had to cut and chisel the old handle off.