Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Jet 1642 Remote Switch Issue

Posts

Jet 1642 Remote Switch Issue

#1

Jet 1642 Remote Switch Issue

Scott Hurley in N. VA

>A few months ago, I installed a Powermatic remote switch on my Jet 1642. Everything worked fine until a couple of weeks ago, when the remote switch quit working, but the main one still worked fine. I removed the remote and tested it with my continuity tester - nothing. I opened the switch case and tested it directly on the contacts of the switch - nothing. I also couldn't see any sort of fuse or anything like that. However, I did notice that the switch has two sets of contacts - I tested the second set and they had continuity when the switch was on. I moved the wires to the spare set of contacts, and everything's OK now. Bottom line - if your remote switch fails, it may be a double pole switch - just move the wires to the second (spare?) set, and it should work again. When the second set of contacts fail...

Scott

Re: Jet 1642 Remote Switch Issue

#2

Dust

Jerry Hall

>is often the cause. I finally put mine in a sturdy plastic bag. No more problems. See the link under "Remote Switch" for lots of discussion.

Re: Jet 1642 Remote Switch Issue

#3

Re: Dust (Link Lost somehow)

Jerry Hall

>Try http://mustardmonster.googlepages.com/ and go to the electrical page, remote switch

Re: Jet 1642 Remote Switch Issue

#4

Re: Jet 1642 Remote Switch Issue

john lucas

>I had the same problem with my Powermatic switch. You can completely dissassemble the switch but pay attention to where everything goes. Then polish the contacts, put it back together and your good to go. This has been a common problem. I tried to seal the areas that I could to keep the dust out but the switch itself has larger openings. Probably the best bet would be to take some sort of rubber or plastic over the switch area.

Re: Jet 1642 Remote Switch Issue

#5

Dick Hines

Re: Jet 1642 Remote Switch Issue

Dick Hines

>For your remote switch go to one of the big box stores anf get a plastic box. Drillyour own holes just big enough to get the wire through. Run your wire and seal the hole from the inside. You can also get gromets that will keep the dust out.