Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

s-curve tool rest for mini lathe question

Posts

s-curve tool rest for mini lathe question

#1

s-curve tool rest for mini lathe question

eric_s

>I am considering purchasing one of the cast iron s-curve rests for doing bowls on my mini lathe. Anyone have any experience with these? I broke the cast rest that came with the lathe and have since replaced it with a variety of rests welded up from 5/8 rod, so I am a little concerned about a cast iron rest of this size. I could fabricate one out of 5/8 round stock, but one of these looks like a cost effective alternative for right now.

Thanks,

Eric

Re: s-curve tool rest for mini lathe question

#2

Re: s-curve tool rest for mini lathe question

john lucas

>I have one and bought another one years ago. The ones that I have are too thick. They won't go low enough for the way I use my gouge. I got rid of one of them and had a machinist mill out part of the other one so i could set it lower but it's still too tall.

I am now using one from the Bestwoodtools. For bigger bowls I like the 1" bar but for a mini lathe the 5/8" is fine.

Re: s-curve tool rest for mini lathe question

#3

Re: s-curve tool rest for mini lathe question

eric_s

>Thank you John. This is exactly the type of info I was looking for.

Eric