Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Slightly OT: cutting cut nails

Posts

Slightly OT: cutting cut nails

#1

Slightly OT: cutting cut nails

keith zimmerman, Normal IL

>I have some cut nails, actually spikes, some of which are old wrought iron and some that are new steel. I have need to cut some of them and was wondering if there was a best way to do this. I imagine a hacksaw would work, but I was wondering if there was something a little easier.

keithz

Re: Slightly OT: cutting cut nails

#2

Re: Slightly OT: cutting cut nails

Stuart Johnson

>Dremel with a cut off blade or a die grinder.

Re: Slightly OT: cutting cut nails

#4

Ditto-the dremel with cutoff wheel

john lucas

>

Re: Slightly OT: cutting cut nails

#5

Steven Antonucci

When all else fails: Dremel

steve antonucci

>It's my go to shop tool. Couldn't live without one.

Steven

Re: Slightly OT: cutting cut nails

#6

Re: When all else fails: Dremel

Mac

>Sawzall will do it.......also....

Re: Slightly OT: cutting cut nails

#7

Doh!!! I should have thought of my Dremel. Thanks

keith zimmerman, Normal IL

>

Re: Slightly OT: cutting cut nails

#8

Re: Slightly OT: cutting cut nails

John K Jordan

>Some cut nails are hardened which would be difficult to cut with a metal-cutting blade in a sawzall or hacksaw. I too would reach for the Dremel. The small cutoff wheels are thin and don't waste much metal.

BTW, about 40 years ago I came up with a great application for these little cutoff wheels. When motorcycles were commonly assembled with philips screws/bolts, removing those with stripped heads was always a problem. I found that I could usually use a Dremel to cut a slot in the head that I could grab with a big flat-head screwdriver bit in an impact driver.

JKJ

Re: Slightly OT: cutting cut nails

#9

I hate philips head screws.

john lucas

>John When I raced my kawasaki I had constant problems with the philips head screws. I did just as you did using either the abrasive wheel or a a slot cutting wheel and used the impact driver to remove them. I finally learned that Kawasaki sold an allen head screw replacement kit so you could replace every one of those stupid philips screws. What a life saver.

Re: Slightly OT: cutting cut nails

#10

Motocross? Hodaka's here.

John K Jordan

>

Re: Slightly OT: cutting cut nails

#11

motocross and enduro's mostly

john lucas

>Compared to what they do today I'm not even sure we were racing. I'm amazed by the capabilities of both bike and rider today.