Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

jet 1236-broken belts

Posts

jet 1236-broken belts

#1

jet 1236-broken belts

Nick

>I've been going through a lot of drive belts,particularly when I run the lathe at low speed. The pulley bearing moves freely on its shaft-that's not the problem. It just seems that the tension is too much at low speed. Can this be adjusted? Any suggestions (other than not running at low speed)? Thanks

Re: jet 1236-broken belts

#2

Re: jet 1236-broken belts

Tony

>I've got no help--my 1236 never did that. I finally replaced the belt after a couple of years of hard use because I thought I should, not because it needed it. Sorry for the lack of help.

Re: jet 1236-broken belts

#3

Check the sheaves...

Peter Teubel

>You might have a burr on one of the sheaves that's causing the premature belt wear. I used my Jet 1236 hard for a few years until it was compost, but only wore out one belt.

Re: jet 1236-broken belts

#4

Re: Check the sheaves...

Nick

>Thanks. I'll check.