Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Making aluminum caliper?

Posts

Making aluminum caliper?

#1

Making aluminum caliper?

LARRY BISBEE

>I would like to make my own calipers out of aluminum, but can anyone tell me the best thickness to use, the best way to cut the caliper shapes from a sheet of aluminum, and would aluminum alloy 5052-H32 be okay to use for this project? In a demonstration at the 2008 Southern States Symposium, Avelino Samuel used three different sizes of these calipers to measure the thickness of his vessels and I have also seen them used before in other demonstrations. Suggestions and comments would be greatly appreciated.


img

Re: Making aluminum caliper?

#2

Re: Making aluminum caliper?

John K Jordan

>Larry,

You can easily cut aluminum to the shape you need with a woodworking bandsaw. Since there will basically be no force on the calipers, almost type of aluminum and any thickness enough to keep it from flopping should work fine.

JKJ

Re: Making aluminum caliper?

#3

Don't use your 3TPI blade though!

Bill Howatt

>

Re: Making aluminum caliper?

#4

Larry, I made mine...

Allen Neighbors

>from an old STOP sign the highway department threw out in the metal pile at our landfill. It is stiff, and works perfectly. I used a metal blade in my jigsaw to cut it out. I drew two 3/4" wide Ss, side by side on the backside of the sign. Then I cut them out, and flipped one over and put a small bolt and wingnut in the center. It's now in the shape of a figure 8, split at the top and bottom. When it's apart 1/8" at the top, it's apart 1/8" at the bottom too.

Two or three different sizes of these will work, also, and they're not so hard to draw and cut out.

Re: Making aluminum caliper?

#5

Re: Larry, I made mine...

john lucas

>I built a different one but I used plexiglass. I used a scroll saw.

Re: Making aluminum caliper?

#6

Re: Larry, I made mine...

robert davis

>imade twosizes similar to photo from scrap aluminum appx 1/16 thick using metalcutting blade in scrool saw. very slow speed . lubricate with wax