Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Turning Chestnut Wood

Posts

Turning Chestnut Wood

#1

Turning Chestnut Wood

Jim Tusant

>I acquired some green Chestnut. I am having trouble turning the wood. It seems that no matter what I do the gouge wants to bounce. I cut the wood the traditional way by splitting the log down the pith and cutting out the blank on the band saw. I securely mounted the piece between center. I faced off the end by shear scaping with the bowl gouge and when I tried to rough turn the outside, I continuely get bounce. I am not using pressue on the tip end and I am running the bevel but get nothing but bounce. I have never had this problem before with other woods and I wonder if anyone else has had this problem with Chestnut.

Re: Turning Chestnut Wood

#2

Re: Turning Chestnut Wood

Stuart Johnson

>I've never turned Chestnut but I had this problem with some Cherry. Two blanks from the same board and one was so bad I lost it. The other I was able to finally get something half way decent. I think the problem is the blank never did balance. I don't know if this was caused by different density but even after the blank was dry it didn't balance. It was bad enough that I thought I might have bent the spindle on my lathe. This wasn't the case because I didn't have any problems with the next blank.

Re: Turning Chestnut Wood

#3

Re: Turning Chestnut Wood

GaryG in MD

>It may have to do with the grain direction. I'm just guessing, but try cutting in both directions -- I'm guessing that you'll find it works better one way. ...Gary