Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Stihl won't start

Posts

Stihl won't start

#1

Stihl won't start

Stuart Johnson

>My new (less than year old) Stihl chain saw won't start. I have used less than two tanks of gas which is probably the problem. It has been five or six months since I used it. It has set with about a half tank since the last time. After 20 or so pulls with out any hint of firing I emptied the tank and can. Mixed up a fresh batch and refilled the tank. Still nothing.

Any suggestions on the next steps to take?

Re: Stihl won't start

#2

Re: Stihl won't start

Sam Scalzo

>Try spraying the spark plug with wd40. Should start. Sam

Re: Stihl won't start

#3

Steven Antonucci

That's odd?

steve antonucci

>Mine will sit forever with almost no ill effect. Once it starts (usually 2-3 good pulls), it starts first time, every time.

Check the plug? If you aren't getting signs of life, it may be electrical. I'd also check the fuel line to make sure it's getting gas, but in 6 years, I've never had an issue.

Steven

Re: Stihl won't start

#4

Re: Stihl won't start

adrien

>BTW, add gas stabilzer to the can each trip to the station. That way if the saw sits unused for six months it won't gum up

Re: Stihl won't start

#5

Re: Stihl won't start

Peter Teubel

>Sounds like you have a clogged carb due to old UN-stabilized gas.

#1) Get some gas stabilizer and add it to your gas can NOW. That way you will never forget when you fill the saw.

Here's what I would do:

Remove the spark plug and spray some starting fluid directly in the cylinder.

Remove the air filter, open the choke, and spray starting fluid down the carb throat. Don't get it drippy wet with fluid otherwise a backfire could ignite the spillover.

Try to start it with the choke OFF and the throttle in the start/high-idle position. If it tries to fire, apply full choke and continue starting.

If you smell gasoline, you've probably flooded it. The way to clear a flooded gas engine is to try starting it with NO choke and the throttle WIDE open. This is always "fun" with a chainsaw. Remove the bar and chain if you are not comfortable with this technique or set the chain brake.

From my experience, every two-stroke engine develops their own unique starting procedure. For example, both my MS170s (from dead cold) require 5 pulls at full choke, then 2 pulls at fast idle. Every time. Without fail. I can set my watch by them. My MS390, 4 pulls at full choke, then one at fast idle. My MS180E starts instantly when I pull the trigger (electric) ;)

Re: Stihl won't start

#6

Re: Stihl won't start

John K Jordan

>Stuart,

Old gas and fouled plug are the biggest cause. (Remove the plug, connect the wire, ground to the engine, pull and look for spark; compare to a new plug.) A guy I know will heat the plug in another engine or with a torch for a cantankerous engine.) Also check the air filter, but that is unlikely to be a problem with a new saw.

Not intended to insult you, but are you following the starting sequence? I have two Stihl saws and both are the same - if I don't follow the sequenced exactly neither will start easily. Sequence: Hold trigger and push choke lever all the way down; pull until the engine blips once; click the choke left up (it will go one notch); pull rapidly three times. My saws both start every time on the third pull. Strange but true.

Also, I had a Stihl once that was really a pain and hated to start. I returned it and got another.

JKJ

Re: Stihl won't start

#7

Re: Stihl won't start

Curly Smith

>In addition to the other recommendations, make sure that your fuel line isn't cracked. If your Stihl has the "accordion" style line then you'll need to physically inspect it as a break may not be obvious.

Re: Stihl won't start

#8

Denis Putland

Re: Stihl won't start

Denis Putland

>Peter when you say

"Remove the spark plug and spray some starting fluid directly in the cylinder."

Are you talking the starting fluid with Ether as a component use it with extreme caution.

That stuff has caused many an engine overhaul.

Denis

Re: Stihl won't start

#9

Re: Stihl won't start

Stuart Johnson

>Well enough is enough. I tried most of the tips with no luck. I can't see the plug sparking but I'm not 100% certain I have it grounded. I'll take it into the dealer this afternoon. Something less than nine months old shouldn't require fussing with to run.

I thought the Stihl oil had a stabilizer added but in any event I don't think that is the problem. It is definitely getting gas. Now if the guy in the service department starts it with one pull I'll probably need to kill him.

Re: Stihl won't start

#10

Yes...

Peter Teubel

>I'm not talking a LONG stream...just a quick burst. I've done that for decades and have yet to have any engine suffer from it.

Re: Stihl won't start

#11

Steven Antonucci

My uncle did a "long stream" once...

steve antonucci

>In my 1975 Ford Grenada. It had cold start issues, so he went at it with the ether and when he hit the key, it backfired (violently)out of the carburator and caught the underside of the hood on fire (briefly).

That car was a piece of work. It never ran well, but always ran.

Steven

Re: Stihl won't start

#12

Re: Stihl won't start---- Running Now

Stuart Johnson

>Okay, I've got to admit I would like to be saying the thingy was bad and it caused the other thingy to not work.

Fortunately although embarrassing it was operator error. According the the repair guy the only problem was it was flooded. I did think of that and I think it was mentioned here so I went through the steps called for in the manual but it didn't work. The fellow said I probably didn't get the spark plug dried enough. He said the best thing was to have a spare plug and switch them. Anyway it is running and it is raining so another day will pass before I use it.

Thanks to everyone for the tips.

Re: Stihl won't start

#13

Re: Stihl won't start

Greg Burnard

>When I have trouble starting one of my chain saws Stihl or other, I first check to see if the anti-kickback feature needs to be reset. If it it isn't reset it will flood.

Re: Stihl won't start

#14

Re: Stihl won't start---- Running Now

Fog Tanner

>After a lot of years dealing with various two cycles and having a Stihl that was prone to flooding, I had to learn how to deal with flooded engines. It really is fairly simple. You pull the plug and crank it through several times. Put a rag over the plug hole to catch the excess and keep dirt out on the down stroke. The crankcase will have some fuel mixture and you have to get rid of most of that. You don't have to get it all out, but enough for it to fire. It may sputter for a second or two but will clean up fairly quickly. As far as the plug, all you have to do is blow on it and get any excess fuel off. When you crank your engine, the plug is going to get wet. The problem is when you have enough fluid to bridge the air gap and it just shorts through the liquid and you get no spark.

One of the problems with flooding the engine really bad and tring to pull it through is engine damage. Anything from piston to rod from the stress of trying to compress a liquid. That would be the one hazard of have an electric starter for a chainsaw. You could bend a rod or crack a piston real quick.

Re: Stihl won't start

#15

Try A Brand New Spark Plug

Barry Turner

>