Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Cutting Corian

Posts

Cutting Corian

#1

Cutting Corian

Craig Daymon

>What is the best method to cut Corian? I have a couple sheets of Corian, about 3/4" thick, and I want to cut some pieces for some small turnings. Are there any issues with using the tablesaw? Any reasons not to do so? (I won't use one of my good blades.)

Thanks,

Craig

Re: Cutting Corian

#2

Re: Cutting Corian

jwoodwright

>I cut loads of Corian. 3/4" is really tough and it's truly a case where you must let the blade cut at it's rate. You can't muscle it through.

I use at least a 40 tooth 7 1/4" Carbide tip blade on my Delta Contractors Saw. The more teeth, smoother the cut. I've used 60 teeth and they work. Why tear up a $60.00 blade when a $10 blade does a great job?

If you can wheel your saw outside, all the better. The Installation guys all wear breathing protection. The mess is great and it gets all over. I've found cutting some wood, after you do the Corian makes clean-up easier. The sawdust and Corian dust seem attracted to each other. This also cleans up your blade... John

Re: Cutting Corian

#3

Re: Cutting Corian

RPE

>It works just like wood. But as mentioned above, wear dust protection. Very fine dust, similar to when you cut MDF, is produced. It gets everywhere. It finishes up well. Sand through grits. Treat it like wood.

RP

Re: Cutting Corian

#4

Thanks, I'll make sure to wear a mask.

Craig Daymon

>