Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Allen wrench chisel

Posts

Allen wrench chisel

#1

Allen wrench chisel

Bob Macgregor

>In the past I have seen mention of using allen wrenches as chisels. Are there pictures of the way these should be ground? Is this a good tool to use to undercut loose rings?

BOB

Re: Allen wrench chisel

#2

Steven Antonucci

In a word, sure...

steve antonucci

>Grind the top of the key flat about 1/2 way through, and then a bevel angle on the bottom half. Drill a hole in some wood smaller than the key and put a drop of CA before jamming the key in the hole. assembly time: 5 min.

Keys are so hard, they take a good edge and cut like mad...

Steven

Re: Allen wrench chisel

#3

Re: Allen wrench chisel

Brian Hahn in SW Wisconsin

>Here is a picture of my Allen wrench tools. I don't do captive rings, but people around here use old dental tools that have been sharpened to get behind the ring.


img

Re: Allen wrench chisel

#4

Re: Allen wrench chisel

George Van

>Thanks for the idea of what to do with the old keyless chucks I have accumulated from old rechargable drills Brian!

Re: Allen wrench chisel

#5

Re: Allen wrench chisel

Bob Macgregor

>Thanks. Last weekend I made a mounting bar with different-sized holes in each end and set screws to hold the home-made bits. Next I'll make a handle, also with set screws, to hold the reversible bar. Allen wrenches seem to breed in my workbench drawers, so it will be nice to put some of them to use now that I have a better idea of how to make them into cutting tools.