Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Vacuum Chuck & Platter Issue?

Posts

Vacuum Chuck & Platter Issue?

#1

Vacuum Chuck & Platter Issue?

Stuart Johnson

>I have been working on a Cherry platter that is giving me a problem. I normally use a compression tenon but on this one I used my chuck in expansion mode. When I reverse turned the bottom I used my vacuum chuck.

I can now see a faint outline circle of lighter wood on the inside of the platter and a slightly darker circle that matches the recess left in the bottom for the chuck. I'm hoping this will all even out after I leave the platter out in the sun for awhile to darken.

I've never had this show up before but this is the first time I ever used the expansion method rather than compression. Any ideas on what caused this and do you think darkening will have the desired effect? The platter is not excessively thin.

Re: Vacuum Chuck & Platter Issue?

#2

Re: Vacuum Chuck & Platter Issue?

Bill Howatt

>Interesting. Did you apply finish while it was under vacuum? I have had finish pulled through the wood in the vacuum area which made a slight difference in color but wiping it and applying more finish to the entire piece made it go away.

Was the wood dry, ie, did you pull moisture out of the vacuum area?

Bill

Re: Vacuum Chuck & Platter Issue?

#3

Re: Vacuum Chuck & Platter Issue?

Stuart Johnson

>No finish was applied under vacuum and the wood had been soaked in DNA and then dried. I think I probably pulled something into or out of the wood with the vacuum. I'll put on a couple more coats of Watco Danish Oil and see if it evens out before I put it in the sun.

Re: Vacuum Chuck & Platter Issue?

#4

That happened to me once

Ron in Drums PA

>Not sure if it's the same problem you are having.

On mine it looked like I crushed the fibers just enough not to make an indent but just enough so the light would reflect differently.

Re: Vacuum Chuck & Platter Issue?

#5

Re: Vacuum Chuck & Platter Issue?

Stuart Johnson

>I was able to get a picture today that shows the two areas. The darker ring is the recess for the chuck. The lighter one is the exact shape and size of my vacuum chuck. Sunshine will probably even things out just fine but I would like to prevent this from happening in the future. In hindsight this is the lightest wood I have used vacuum with. I might have had the same issue in the past but because it was on either Mesquite or the inside of a hollow form I've never noticed it.

By the way the Cherry blank was received in a trade with Steve Antonucci. Now if I can just get a nice finish so I can post some decent photos. This one is way too large


img

Re: Vacuum Chuck & Platter Issue?

#6

Steven Antonucci

Ohhh, it's going to be a beauty!

steve antonucci

>can't wait to see the finale

Steve

Re: Vacuum Chuck & Platter Issue?

#7

Re: That happened to me once

Pete in Holland, MI

>Vacuum chucking on semi-porus woods (wood feels kinda sticky while under vacuum) sucks sanding dust into the pores and may discolor the wood in the vacuum area.