Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

How strong is superglue?

Posts

How strong is superglue?

#1

Aage Rendalen

How strong is superglue?

Aage Rendalen

>I grew cocky and did not coat my rough-turned cherry bowl with anchorseal. (In the past I have hardly ever lost a bowl to cracking.) I sealed up the cracks with thin superglue and went ahead and finish-turned it. The bowl was fairly big at 17" and the vibrations generated during finish-turning was enough to destroy the superglue bond. I then went ahead and filled the three cracks that went from the rim to the transition area of the bowl with sanding dust and soaked it in superglue. Yesterday when I picked up the bowl it went snap, crackle, pop on me and the biggest of the cracks opened up again.

My question: is superglue normally that feeble? Should I switch to traditional yellow glue instead? And if I do, will the result be good?

Re: How strong is superglue?

#2

Re: How strong is superglue?

Fog Tanner

>The strongest of the glues for gap filling is epoxy with a filler. the CA glues are good for some things, but are at their best when you have a tight joint. They are faily poor at gap filling, the "gap filling" bottles just being CA with a filler and a longer set time. CA glues are at their worst when put into a shearing type stress and a little better for gap filling. But get two mateing surfaces and the joint will be stronger than the wood. The wood also cannot have any oil on or in it.

The use of the wood dust with the CA is more of a cosmetic filler and if you have stress from the wood moving, it will probably break again. A good 30-60 min epoxy will work with a binding agent (i.e coffee, brass filings, etc). The binding agent adds strength to a large gap, helping hold it together. The down side of epoxy (other than 5 min) is it takes seven days to cure. It has a pot life of 15, 30, or 60 minutes, a set time of 2-8 hours, but to reach full cure is seven days. You can machine it after about 36-48 hours depending on the temp. This would be true for the typical epoxy you are likely to buy. There are specialty epoxys with other set and cure times, but you won't find them at the hardware store.

Moisture content also has a lot to do with the CA bonding. Too dry and it will not bond, I have had to mist water on some joints to get the glue to set. Also the accelerator will weaken the glue joint, I have never had a need for anything faster than 1.5 seconds anyway.

Re: How strong is superglue?

#3

Re: How strong is superglue?

Bill Howatt

>Your problem might be due to the fact that CA glue is very brittle. It cannot accommodate any movement in the wood so if the forces are high it will break. This is why it can be used for wasteblocks on wet wood but you have to get the job done in a few hours since the contraction from drying will break the bond.

Regular PVA white/yellow glue may be worth a try since it does have a bit of give but I've never tried to salvage a bowl that is cracking - void filling and treating bark inclusions, yes, but cracked means scrap to me.

Bill