Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Vise???

Posts

Vise???

#1

Vise???

Jeff Lyon

>There is a device that one can insert into a hole like when turing a pen to hold it. It has a ground out area and a small pin fits in that area. When you turn it, it tightens up and holds your piece.

I can't remember what it is called. Can one buy them somehwere?

Re: Vise???

#2

Re: Vise???

john lucas

>It's called a pin chuck. You used to be able to get a 3/8" pin chuck from Craft supplies. I asked Vic at Bestwoodtools if he made any and he said he used to but no one bought them so he quit making them. I've seen a 1" pin chuck but don't know where it can be purchased.

Re: Vise???

#4

Try Packard Woodworks *LINK*

Brian Hahn in SW Wisconsin

>Packard Woodworks carries a pin chuck. Plus they are a WoodCentral sponsor :))


Packard Woodworks Pin Chuck

Re: Vise???

#5

Re: Vise???

eaglesc

>I make my own "custom" pin chucks for any tube size for any given pen I with to make.

A piece of Corian and a 1/4" bolt from the hardware store.

I cut off the head and because the M2 adapters I sue for the mandrels have a 1/4-28 thread I can just screw the pin chucks into the threaded hole instead of the usual mandrel.

I needed two pin chucks for this particular pen, a full sized "Gent" from CSUSA.




img