>I'm in the market for a curved tool rest for my Powermatic 3520b. Is there one available that can be used on the interior and exterior of bowls? I'll probably be making bowls up to 16" in diameter. Also, any idea if Oneway's exterior tool rests are the same as the ones that Craft Supplies sells? By the way, the lathe I just upgraded from was a Jet mini and what a difference :)
>I bought a very nice one at the Louisville Symposium a couple years back from the guy who builds the Robust Lathe. It was a little salty but it is definitely....robust!
>Hi Kurt, I'm definately looking for "robust" but I'm unable to find a picture of that particular toolrest. Do you have a picture or know of a link to it and does it have a 1" toolpost? I emailed Robust for more info, waiting for there response. Thanks in advance, Jeff
>Brent just sent me a pic of their curved rest. He says they are polished up more than the one in this pic, but it was all he had at the time. Looks pretty "robust" to me.
>I have the Oneway rests for my PM. The inside one does get a bit bounch when you are out on the end of it. They used to fit the PM, then they changed and made the post shorter to fit their 16 inch lathe, and they wouldn't fit the PM anymore. I think that they now make a longer one that fits the PM, but do check. I did talk to Brett (my Robust will be here in about 3 or so weeks) about his tool rest, and he said it gets a bit bouncy on the very end also. The ones pictured here don't make it clear if he has the piece of hardened steel on the top of this rest also. Some one needs to make an inside bowl rest that is similar to the Oneway coring system with a support finger welded at an angle to the underside of a curvet tool rest (of course, it has to sit down in the banjo, so may have to have different sizes for different lathes). I will probably have to get one custom made since I don't do metal work. I don't like tool bounce in the bottom of a big bowl.
>Randy Privett has a nice looking curved tool rest with a more substantial support than I have seen on others (and the one I have). I have the BWT rest and it does vibrate out on the end a bit when used on the inside. I find I do not use it very much.
>Hi Dick, you're probably right and I could do without the curved rest but I think I'd prefer to have a rest hugging the shape of a bowl over extending the gouge 2"-3" over the rest or constantly readjusting and working off the end of the rest. Just boils down to a matter of preference I guess but definately not a necessity.
>Hi David, that rest looks like it would work well with that extra support beneath the top bar. I might just have to save up a few more pennies for that one. Looks like it would handle vibration better than most. Thanks.