good sharpening video *LINK*
john lucas
>
http://www.youtube.com/watch?v=cRqcth2rBaE
Knowledge You Can Build On — Est. 1998
good sharpening video *LINK*
john lucas
>
http://www.youtube.com/watch?v=cRqcth2rBaE
Re: good sharpening video
Ron in Drums PA
>As I was watching the video, I couldn't help but but notice how much steel Stu was grinding away while he was sharpening his 3/8" gouge. One or two passes is all that is needed, unless of course there was a problem with the edge to begin with.
The difference between sharp and dull is about .002"
Re: good sharpening video
Stuart Johnson
>Ron, I think he was just grinding to demonstrate the process.
Re: good sharpening video
Ron in Drums PA
>You are probably right Stu.
But a person who is just starting out learning how to sharpen may not realize that.
But the sparks are pretty.....
Stuart Johnson
>
I was wondering.......
Barry Irby
>If he forgot to reposition the support arm. I would have to watch it again, but he mentioned and showed all those templates for the various setups. You don't suppose he failed to use a template designed for the 3/8 gouge?
Good video either way.
Re: I was wondering.......
Ron in Drums PA
>Barry,
I never move the arm on my homemade "Woverine" sharping system. Instead, I have a story board with different marks for different size and types of gouges. The length of the tool sticking out of the holder varies from 1-3/4" to 2-3/8", but for my 3/8" and 1/2" gouge it is exactly the same at 2".
Different stokes for different folks.