Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Vic Wood/Tim Skilton sanders?

Posts

Vic Wood/Tim Skilton sanders?

#1

Vic Wood/Tim Skilton sanders?

wilbur

>After trying real hard to improve my sanding techniques, I was thinking about giving one of these models a try. Does anyone have any comments on these self powered sanders, or any others I don't know about?

I do have an electric drill I could use for powered sanding, but it's kind of heavy, so I'm not real thrilled about using it.

Re: Vic Wood/Tim Skilton sanders?

#2

Re: Vic Wood/Tim Skilton sanders?

Wally Dickerman in Arizona

>I've had a Vic Wood inertia sander for a long time. I like it very much. I've used it on hundreds of vessels and the bearing and the velcro are still good. It doesn't work well on the inside of a bowl. Your power sander is better there. I seldom turn bowls so that doesn't matter to me. Works well on my hollow forms.

Wally

Re: Vic Wood/Tim Skilton sanders?

#3

Re: Vic Wood/Tim Skilton sanders?

eliot d

>You can make a self-powered sanding tool in a few minutes. It's basically a stick with a hole in it, where you put the sanding mandrel shaft. I use one from time to time instead of a power sander, and it works great. I would say that for sanding non-problem areas on the outside of a vessel or bowl, you will even do better than a power sander with respect to not getting sanding scratches.For problem areas ,though, using a power sander --even your heavy one -- for a few seconds with the lathe stopped is hard to beat.

Re: Vic Wood/Tim Skilton sanders?

#4

Re: Vic Wood/Tim Skilton sanders?

Fog Tanner

>I have one of the Vic Woods sanders which I have been using for the last 6 or 7 years. I use it on bowls, inside and outside and some spindle items on the outside. I can get it inside a 4" bowl, but it gets crowded in there. I need to get/make another one with a 2" pad for the smaller bowls like the 3" and 4".

Last year I finally bought a cheap Harbor Freight angle drill ($25) for some pieces that I cannot use the inertia sander on. Its easier than using a regular drill for that. And since it came from Harbor Freight you know it has to be good.....

Re: Vic Wood/Tim Skilton sanders?

#5

Re: Vic Wood/Tim Skilton sanders?

Allen Neighbors

>Wilbur, I made my own.

Rollerblade wheels; 1/4" allthread epoxied inside the bearing; 1" or 3/4" dowel handles. Handles bent at about 45 degrees.

I use flip-flop soles for the pads; Industrial strength velcro; Vince's disks.

I use contact cement for the glue on the pad and the velcro.

They work well. Inside and outside of bowls.

4 years, and I've only worn one out, that I can remember.