Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

wood movement

Posts

wood movement

#1

wood movement

woody vt

>Hello everyone!! When turniing thin walled vessels(1/16"t + or -)I am having trouble with the bowls coming out of round as I hollow them out. This usually happens when the walls are under 1/4" thick. When this happens, I have been going back and truing up the outside and then returning to the inside. This is with KD wood. Any hints, tips, strategies to deal with this? Thanks in advance.

Re: wood movement

#2

Peter Charles Fagg (UK)

Re: wood movement

Peter Charles Fagg (UK)

>Over the years I have turned many platters of around 2 feet in diameter with a thickness of about 14"-1/8" and movement is often quite marked. Sometimes so much that I have unfortunately cut right through and reduced the diameter drastically!

I usually allow the platter, whatever, to run and steady it in a leather gloved hand, enough to let it slip through my fingers. (to reduce burning of my fingers) It is not always successful but worth trying!

Peter.

Re: wood movement

#3

Re: wood movement

Gary Evans Tallassee, TN

>One of the fallacies regarding KD wood is that it is actually dry uniformly all the way through, particularly on wood thicker than 2". Regardless of the MC at the point or points where the measurement was taken, there will almost always be moisture gradients throughout a particular piece of wood; hence movement as you expose previously unexposed wood to the atmosphere.

The other issue is the stresses that build in the wood as it is being dried. When the wood is still in the form of the cant in which it was originally dried, those stresses are balanced through the piece. Once you cut it up into smaller pieces, those stresses can stay in the wood and show up when you least expect them. Ever had a piece of kiln-dried wood pinch your sawblade when you were ripping it? Same principle.

Roughing out to 10% and then letting wood set for awhile is not a bad idea, even with KD wood. KD wood, depending on the MC when you got it, shouldn't have to sit long to equalize with the area where you have it and relax some of the stresses within. Be nice if you could just feed it a valium. 8^]

Gary

Re: wood movement

#4

Re: wood movement

john lucas

>When turning a thin green bowl I turn the outside. Then I rough out the inside to about an inch thick maybe even leaving the bottom 1/3 a lot thicker. Then I thin out the bowl an inch at a time and never go back. When I thin the second inch I blend this into the 1st inch but I try not to go back beyond the transition point anymore than necessary. You will find on many woods that the bowl will warp to the point that you can't go back without ruining it.

To sand slow the lathe way down or simply turn it off and sand.

Re: wood movement

#5

Re: wood movement

Texian

>John Lucas covered it well. Have frequently observed that a KD piece on the lathe that was round last night is not round this morning. Another example: A segment cutting sled consisting of a plywood board and two oak runners glued to the bottom that slide in the two miter slots of the table saw- at 72 degrees and 50% humidity in the shop the sled slides easily, and at same temp. and 70% humidity (rainy weather), the sled does not slide without considerable force.

Re: wood movement

#6

Re: wood movement

john lucas

>Texian I replaced the runners on my sled with plexiglass for exactly the reason you mentioned.