Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Supernova Jaw Screws: Two sizes!

Posts

Supernova Jaw Screws: Two sizes!

#1

Supernova Jaw Screws: Two sizes!

Jerry Hall

>A while back I bought a SN2 to complement a SN2 I bought years ago that had a set of long nose jaws (now discontinued.) The screw heads from the new SN2 are a bit larger by a few thousanths and get caught in the long recess of the long nose jaws and are also a tight fit in all the jaws. I have had to pound them out of the recess when changing jaws. All the screws are labled "Nova." Now I have to keep track of 2 "types" of screws and am on the verge of painting the heads of the "good ones." Any one else with this problem? Does anyone know of a source for Nova screw sets available that might have been made to more accurate tolerances? I thought I was living good with two Nova Chucks, but this is "screwing" me up. You would think Nova could make machine screws that are accurate/consistent to a couple thousandths or so.

Re: Supernova Jaw Screws: Two sizes!

#2

diameter?

John K Jordan

>Do you mean the diameter of the top of the screw is a bit to large for the countersunk hole?

If so, I had some like that. I took a small diamond hone I had at hand and took a few atoms off the rim of the screw until they fit easily.

JKJ

Re: Supernova Jaw Screws: Two sizes!

#3

Re: Supernova Jaw Screws: Two sizes!

Dave Noon

>I doubt that Nove makes their own screws. However, the screws they do use are a standard M6 Flat Head Cap Screw. May be available form your local hardware store.

Dave

Re: Supernova Jaw Screws: Two sizes!

#4

Re: diameter?

Jerry Hall

>John,

Yes exactly right: the major diameter of the head is too big for the hole. I wrapped and rubbed them with sandpaper, didn't do much of course. I will try your idea. Diamond hone is a good idea and may remove three or so thousandths. Now that I think of it maybe I can put them in my drill chuck and spin them across the hone. Thanks!

Jerry

Re: Supernova Jaw Screws: Two sizes!

#5

Re: chuck in elec. drill and head to tool grinder

Al Crandall -NW of Indy-

>

Re: Supernova Jaw Screws: Two sizes!

#6

Re: Supernova Jaw Screws: Two sizes!

Wilford Bickel

>Jerry, I ran into the same problem on a set of 45mm step jaws in the deep holes about 18 months ago. I had the jaws about a year longer then that. I emailed Teknatool and they mailed me some new screws - same problem. Since I now had an extra set of screws I took 4 and ground the heads enough that they drop in with no problem. I keep them in a small medicine bottle with the jaws so I know which ones they are and have had no further problems.