Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Thompson Detail Gouge

Posts

Thompson Detail Gouge

#1

Thompson Detail Gouge

Cory in MN

>I've seen some posts in the past few months mentioning Thompson Lathe Tool's detail gouge. After visiting Mr. Thompson's web site, I'm curious if those glowing recommendations were for the standard detail gouge, or shallow detail gouge. I'm certain they are both very good, but am curous what everyone is using.

Thanks,

Cory in MN

Re: Thompson Detail Gouge

#2

Re: Thompson Detail Gouge

john lucas

>I like the shallow detail gouge the best but it depends on what you are using it for. What I like about the shallow gouge is there is a lot more mass underneath the cutting edge. This means it has less vibration when it is extended over the tool rest like when cutting a cove or a shallow neck on a lamp where you can't get the tool rest close to the work.

Re: Thompson Detail Gouge

#3

Re: Thompson Detail Gouge

Doug Thompson near Cleveland

>The 3/8 detail is the tool everyone gets, the shallow detail is made for offset turning that extend far over the rest.

Tomorrow I'll pick up the tools from the heat treatment... I'll also open the site for the tools sold out. It's been busy around here with family so I'm behind.

Re: Thompson Detail Gouge

#4

Re: Thompson Detail Gouge

Gordon Seto

>The shallow flute detail gouges are also my favorite too. It allows me to reach into very tight area. They are very useful when you can't keep the tool rest close such as off-center turning.

The down side is the flute is narrower. The sweet spot is smaller. It is not as easy to control on long smooth flowing curve.

Gordon

Re: Thompson Detail Gouge

#5

Re: Thompson Detail Gouge

Ken

>Hey Doug,don't forget to save me one of those 5/8 V gouges,soon as I see em up and ready I will place an order.Love those 1/2 an 3/8 I just got.

Re: Thompson Detail Gouge

#6

Re: Thompson Detail Gouge

Doug Thompson near Cleveland

>Ken, we'll have enough V shape tools for a while... it's the U shape that didn't get done this batch but there's enough. Thanks, Doug

Re: Thompson Detail Gouge

#7

Dick Hines

Re: Thompson Detail Gouge

Dick Hines

>I have the shallow detail gouge, love it, use all the time. Will get another one atr the AAW symposium in June. There is another add you you Doug.LOL.