Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Jumbo Jaw Button solution...........

Posts

Jumbo Jaw Button solution...........

#1

Jesper, Denmark

Jumbo Jaw Button solution...........

Jesper, Denmark

>In the end turned out very simple: A local Danish Oneway dealer had them in stock. Price a little more than in the USA and less than quoted in Euro by Oneway. Postage and handling $17 US equivalent and they arrived here today in the mail. Nice seletion of extra screws included.

Too bad that Oneway CA and Oneway Europe did not know or support their local dealer.

The ideas presented in this forum now makes me want to experiment a little with both rubber stoppers for lab gear and crutch feet on a dowel with a hole drilled for hanging onto larger and akward bowls.

All's well that ends well.

Re: Jumbo Jaw Button solution...........

#2

Re: Jumbo Jaw Button solution...........

Bruce in Saint John, Saint John, N.B.

>Glad you were able to locate some buttons, but homemade ones

do work great. I believe in your original post you mentioned the

rubber got hard and cracked, what sometimes happens is that if

you apply finish oils on the lathe and happen to get some on the

rubber, the oils will attack the rubber and make them hard and

brittle. I use quite a bit of tung oil and if I happen to get

some on the rubber buttons I clean it off immediately after removing

the item from the chuck. This for me seems to extend the useful

life of the buttons.

Re: Jumbo Jaw Button solution...........

#3

Jesper, Denmark

Re: Jumbo Jaw Button solution...........

Jesper, Denmark

>That probably is part of the problem, but I have had these for maybe 6 or 7 years, so no complaint about the rubber.

If these last as long as the original ones, they can put them in the coffin with the other tools for the "other" side, like the corkscrew etc.

Re: Jumbo Jaw Button solution...........

#4

Sorry, Jesper, "you can't take it with you."

Allen Neighbors

>

Re: Jumbo Jaw Button solution...........

#5

Jesper, Denmark

You bet'yer I can, but whether it will do any good

Jesper, Denmark

>I am not so sure.

Anyway,it was a nice way ti figger out if anybody were paying attention.

Re: Jumbo Jaw Button solution...........

#6

Re: You bet'yer I can, but whether it will do any

Barry Irby

>Jesper,

I want to make a set of grippers that are sort of rectangular with the holes NOT in the center, so that I can turn them either two or four ways and change the size of the grip. The goal is to reduce the number of times I have to move the buttons.

Re: Jumbo Jaw Button solution...........

#7

Jesper, Denmark

Isn't it strange how........

Jesper, Denmark

>You always guess wrong when you have to move the buttons?