Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Red Oak Limb

Posts

Red Oak Limb

#1

Red Oak Limb

Wayne Carson "TX"

>A couple of weeks ago I did some pruning and cut a 3" limb off my red oak. Saturday I decided to try turning the green wood. It was actually a lot of fun nice flowing pieces. I turned it at 10:00 am and had to go install some cabinets I built. I got back at 5:00 pm and looked at it and it had cracked on one side for the entire length. The center of the limb was red as red oak should be but the outer 2" were white, I assume this is sapwood? Would the sap wood eventuall get red if left on the tree to grow. And is the splitting normal for this type of wood. I have never turned green wood before. I just split is up to see how it would split and it made nice streight grain sticks to small for anything but kindling.

Re: Red Oak Limb

#2

Re: Red Oak Limb

Don at Central Illinois

>I've found that whenever I turn green wood and have to leave it, for even a few minutes, I wrap a plastic bag around it and tape it in place. I had the same thing happen earlier this year with some hackberry. Thought it was dry enough to leave alone, uncovered for an hour or so, and ended up throwing the whole thing away because of the cracks.

Re: Red Oak Limb

#3

Re: Red Oak Limb

Jim Rutten

>Your lucky, Wayne. First time I turned some oak branch, in an attempt to make a goblet, it cracked in midturn. It sounded like a gunshot went off. Thank God I havea strong heart.

Re: Red Oak Limb

#4

Steven Antonucci

Not uncommon

steve antonucci

>I love the streamer and ribbons with wet wood, but the cracking can kill a day's work in no time. A limb most likely had lots of tension in it at the "bottom" of the limb from supporting all of that weight, and when you cut it and turned it, you gave it a means of escape.

I have a maple pot that I left for a day with a 1" split in it...

Steven

Re: Red Oak Limb

#5

Re: Not uncommon

Bill Crommett

>I wish I could find the picture of a beautiful 14 inch tray with 2 inch sides that I turned from what I presumed was sufficiently dry Live Oak. It was a nice piece, until the next morning when found four cracks around the edges and halfway into the middle.

Re: Red Oak Limb

#6

Ric Taylor

Re: Red Oak Limb

Ric Taylor

>Wayne,

I never turn any variety of green oak because it has two bad habits: splitting and warping.

Ric

Re: Red Oak Limb

#7

Re: Red Oak Limb

GaryG in MD

>Cracking has been sufficiently addressed. To answer the other part of your question about the heartwood and sapwood, Google those terms or "cambium layer", and you will learn all about how trees grow. ...Gary

Re: Red Oak Limb

#8

Re: Red Oak Limb

Bill Hale / The Wood Spinner

>Wayne

I have to presume that you were turning end grain. One thing that helps, but may not stop, the cracking issue is to drill a hole all the way through the piece at the pith.

Good turning and be safe

Bill in CG, AZ.