Re: Kelton's Balance Chuck: The Ultimate Solution.
Steve Russell
>Hello Rick,
The first photo is indeed the Kelton Eccentric Chuck, thanks for catching my error! I can't preview my postings when I use my Mac on WC, or I get an error (WebFormBoundaryKitxxx) that prevents me from posting until I go through a long series of steps. Therefore, I posted the photos of the chuck without double checking the photos and I posted the wrong photo. :-o Please accept my apologies for this oversight. I have attached the corrected photo of the Balancer Chuck front view.
The Kelton Eccentric Chuck acts just like like the Kelton Balancer when the spindle is in the centre position. The main difference between the two, is the eccentric chuck allows off centre turning and the balancer does not. However the balancing function of the two is similar.
As for availability of the Kelton Balancer/Eccentric Chuck, both are available once again. You should be able to obtain one from Kelton's representative, Greg Jensen. Last email I had for Greg was: gnjensen@cox.net He is located in Parma, Ohio.
You can also contact Kel McNaughton in New Zealand through his website: www.kelton.co.nz and ask about getting a balancer from a U.S. distributor. These tools are very well built and perform exceptionally well for eccentric turning, or balancing of unbalanced loads during turning. Take care and best wishes!
Steve Russell
Wednesday Night Turning Chat Moderator
