Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

Darkening Cherry In Sunlight

Posts

Darkening Cherry In Sunlight

#1

Darkening Cherry In Sunlight

Stuart Johnson

>Should Cherry be darkened prior to using a finish or after? I have a shallow bowl I want to darkened and finished with Danish Oil. It might go a little faster if I can use the DO first. That way while it is drying the sun can be doing it's thing. But I don't want to screw it up by trying it backwards.

Re: Darkening Cherry In Sunlight

#2

Steven Antonucci

It darkens in sunlight either way

steve antonucci

>but it might "go faster" if you darken, then oil. I think some finishes have UV inhibitors. Even so, a cherry bowl will darken no matter what...

Steven

Re: Darkening Cherry In Sunlight

#3

Re: It darkens in sunlight either way

adrien

>I gather this is not a piece you wish to experiment with, but you might look at

http://www.ridgidforum.com/forum/archive/index.php/t-4194.html

for chemical means (lye solution, ammonia fumes) as a way of accelerating the process

Re: Darkening Cherry In Sunlight

#4

Re: It darkens in sunlight either way

Stuart Johnson

>You're right this isn't one I want to experiment. It's the first Cherry I've turned and while it is a simple shallow bowl I don't want to mess it up. I'll go with Steve and let it darken before I apply finish.

Re: Darkening Cherry In Sunlight

#5

Steven Antonucci

I don't like the effect lye has!

steve antonucci

>I have one end table that I darkened with a lye based solution, and it isn't "old cherry" looking to me... I have used ammonia an it works great, but takes a while to get rid of the smell.

Remember, if you put it in a sunny window, you better turn it at flip it, or it will two-tone on you.

Steven

Re: Darkening Cherry In Sunlight

#6

I'd finish first.

Brian Hahn in SW Wisconsin

>I always apply the finish first. That way the piece is done! Plus I don't have to worry about cutting through the darkened layer if I need to sand it again.

The one caveat is to make sure the Danish Oil has time to cure before you put it in direct sunlight, especially the first coat. Otherwise the heat will cause the oil to bubble out, which is a real nuisance.

A chemical stain like lye will hasten the process and give you significant head start. Unlike Steve, I've never seen a difference between using lye, potash, dichromate or sunlight.

Remember that cherry darkens different amounts depending on who-knows-what. I made a cherry tool cabinet and used a piece of cherry from a different source for the door panels. After twenty years, the panels are still lighter than the cabinet was when it was first made.