Re: No face shield?
Raymond Overman in SC
>Thank you for your concern. When I turn by myself in my shop, I wear a face shield. However, for this demonstration, I sacrificed the safety for the ability to communicate with the host and the camera. I was aware of the danger and made sure the people that were physically in my shop were aware of the danger too. I stayed out of the trajectory of the spinning piece of wood and took precautions by thoroughly examining the piece of wood I was using.
If you want to get picky, I should have turned on my dust collector too and added to the noise on the camera. I probably should have worn my trend airshield and not spoken at all during the turning session, while the lathe was on, so my full attention could be on the piece of work instead of partially on the host of the show.
However, it doesn't work like that on a local cable show that is limited to 23 minutes outside of commercials and isn't used to shooting someone who is suited up in body armor, so I did what I had to do, just as I've seen demonstrators do time and time again at demonstrations and symposiums. I took all precautions possible without compromising communicating to the audience.
As for the disservice, I'm sorry that it didn't come to my mind during this rushed and non-rehearsed show. I should have taken the time to explain that woodturning is dangerous and you should wear all the gear and take all the precautions and that I should be wearing a face shield. Good for you for catching my error and correcting me.
By the way, welcome to Woodcentral. Doing some searching, this looks like your first post.