Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Busy weekend

Posts

Busy weekend

#1

Busy weekend

john lucas

>I try to make the most of warm weather so I spent about 6 hours each day in the shop. Turned 36 wine stoppers and cut out 40 mirror blanks and handles and mounted waste blocks on them. In between I made new drive center for roughing out green bowls. I wanted longer smaller diameter pins that will penetrate the bark or dig in better on punky wood. I'll let you know how it works out.

I also added a small rare earth magnet to my pin chuck. No more dropping the pin on the floor and losing it. Well actually you can drop it but you have to work a lot harder to lose it.


img

Re: Busy weekend

#2

Pin chuck

john lucas

>I bought the little magnets at RAdio shack. I used a milling cutter to bore the recess for the magnet.


img

Re: Busy weekend

#3

Pretty slick!

Jerry Hall

>I will look forward to hearing how your drive center works. It for sure will go in deeper, and may have as much bearing surface, and also should get into more solid wood. I bet it works! It should also be possible to wiggle the blank to balance the wings of the blank I would think as well as the two flute drive, or better.

Re: Busy weekend

#4

Re: Pin chuck

John K Jordan

>An excellent idea! Did you epoxy the magnet into place?

I found out something last summer when fastening a magnet into a fence staple driver to hold the staple into place. JB Weld must be full of feromagnetic powder! (iron?) I drilled a hole, filled it with JB Weld, inserted the magnet, then watched as the JB Weld mixture flowed up out of the hole to gob up on top of the magnet (which extended a bit out of the hole). I repeatedly pushed it back down until it started hardening enough to stay. Who'd a thunk it?

JKJ

Re: Busy weekend

#5

Re: Pin chuck

john lucas

>John That's funny. I just used a small drop of CA but I think the magnetizm would have held it.

Re: Busy weekend

#6

Steven Antonucci

Pin chuck question?

steve antonucci

>What might you use a pin chuck for instead of a screw center? I know what they are and how they work, but I never said to myself 'I need a pin chuck..."

Ordered a bunch of steel last night, so I can make one if I'm missing something?

Steven

Re: Busy weekend

#7

Cool Ideas, John, Thanks!!--------Gil

Gil Jones on Lake Seminole GA

>

Re: Busy weekend

#8

Re: Pin chuck question?

john lucas

>Steve I use this one for bottle stoppers. It's much faster to install and remove the wood. I don't own one of the 1" pin chucks but borrowed one to turn a production set of bowls. It is way faster than a screw chuck. www.bestwoodtools.com sells one. I think Craft Supplies sells the 3/8" which is what is used for the bottle stoppers. I used a nail for the pin. The gap needs to be a few thousands less than the nail is thick. What I did was mill out the opening leaving it about .008 under size. Then I tried installing a hardwood stopper. I filed out the opening until it was snug but still went on easily and locked up.