Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Revolving tail center question?

Posts

Revolving tail center question?

#1

Revolving tail center question?

Barry Irby

>I turn a few hollow forms. I make it a point to orient it on the lathe so that i can leave the tail center mark on the bottom. This is so that when I reverse it later to clean up the bottom, I can bring the tail center back up into the same mark.

It occurred to me that if I had a revolving tail center that would accept a No.2 Morse taper, I could put my diver spur in it and it would free wheel. That way, I could orient the turning either way and still use the tail stock to center it.

Does anyone make a such a thing? Or, how about a drive spur that is made to fit some thing like the Oneway live center?

Re: Revolving tail center question?

#2

Re: Revolving tail center question?

Rick Allen

>The profile of the Oneway "safety" drive (dead center) and the profile of the Oneway live center are the same. They were designed this way to facilitate flipping stock end for end. Please note that the center pin can be adjusted on the "safety" drive.

You can get a live steb center and matching step drive center.

I am unaware of a #2MT receiver which spins.

Re: Revolving tail center question?

#3

Steb Centers...

Peter Teubel

>A Steb center would do what you want. Sorby makes drive AND revolving stebs. Get matching sizes and you can switch back and forth while maintaining dead center.

Re: Revolving tail center question?

#4

JL

Re: Revolving tail center question?

JL

>That's why I like my Sorby steb centre. I bought the drive center a while back and then bought a live centre for the tail stock.

My $0.02.