Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

PM 3520B spindle play?

Posts

PM 3520B spindle play?

#1

Aage Rendalen

PM 3520B spindle play?

Aage Rendalen

>When I push in the bolt that locks the spindle, there is probably some 1/16" play in the spindle movement. Is this a problem? I wonder at times because of late I've experienced problems getting large platters to run true. I realize that as tension is released in large pieces (mostly green) some distortion is inevitable but yesterday I had more trouble with a 19" cherry platter than I thought I should have.

Re: PM 3520B spindle play?

#2

What kind of movement?

Jay in TX

>Aage,

What kind of movement are you talking about, specifically? Is it slight rotational movement, as in the spindle lock isn't exactly sized for the indent in the spindle? Is there play so that you can pull or push the spindle toward from the tailstock, toward or away from you while standing in front of the lathe (as in during spindle type turning)? Can you measure how much 'play'? Just some questions to help us help you. Good Luck, ~Jay

Re: PM 3520B spindle play?

#3

Aage Rendalen

Re: What kind of movement?

Aage Rendalen

>As you suggest, it seems to be a simple function of the spindle lock going into a hole bigger than the locking pin. When I hold the headstock wheel in position, there is no play. Nor does it move laterally. But when the locking pin is pushed in, I can move the spindle sideways around 1-2 mm (1/16).

I only began wondering about this because of the trouble I've had on a few occasions to make large pieces run true.