Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

ebony and epoxy

Posts

ebony and epoxy

#1

ebony and epoxy

R Acuna

>I have turned a shift knob for my truck out of scrap wood and inlayed a ring of ebony in the top. Im using surfboard two part resin and the epoxy does not set on the ebony ring. I have used this resin on other woods and its great. Is ebony that oily that it wont accept the resin? It just stays wet and then I have to wipe it off and leave a mess like in the pics. Anyone have any ideas? Thnx. R


img

Re: ebony and epoxy

#2

Just Polish

Gil Jones on Lake Seminole GA

>I do not know about Ebony and epoxy, but for a shifter knob, I would go back to bare wood and just polish it on a buffer.

Re: ebony and epoxy

#3

Re: ebony and epoxy

Lan Brady

>

Re: ebony and epoxy

#4

Re: ebony and epoxy

Lan Brady

>Well, I will try again.

This is a great project. You did a fine job.

I think there is a shifter knob in my future as well!

Lan

Re: ebony and epoxy

#5

Ellis Walentine

Anti-oxidants

Ellis Walentine

>I admit my understanding of this is sketchy, but I think the ebony may have some kind of anti-oxidant compound in it that interferes chemically with the epoxy curing process. I suspect it is akin to the effect that rosewoods and other oily woods have on polyurethane drying. You might want to take Gil's advice and just sand the knob really fine and buff it with some wax to leave a hard, shiny surface on the wood.

Ellis Walentine, Host

Re: ebony and epoxy

#6

Re: ebony and epoxy

Steve in NC

>I have had trouble with old epoxy curing. I now buy smaller bottles and squeeze the air out when storing. Just a thought.

Steve

Re: ebony and epoxy

#7

Re: ebony and epoxy

eaglesc

>I have had issues with getting CA to stick on ebony in the past.

With glue ups that I do using aluminum and ebony I have come up with a way of finishing that has been giving me good results using Krylon spray acrylic as a sealer and Unaxol water based lacquer as the finish.

I spray the Krylon on and after it HARDENS for 2 days I hand "sand" with the last 5 "grits" of micro mesh and apply the top coat of lacquer on that.

You will get a high gloss with the acrylic which seals the oily woods.

I don't know if the heat of the vehicle will cause issues wth the oils in the ebony down the road.

Another thought would be to cast the knob as finished in clear resin and re-turn and polish.

Re: ebony and epoxy

#8

Re: ebony and epoxy

Mark in B'ham AL

>I don't know about the ebony, but I have had trouble too with epoxy drying. I chalked it up to the cheap brand I was getting at the BORG, the one that comes in the double syringe. I just kinda gave up on epoxy in general.

Re: ebony and epoxy

#9

Re: ebony and epoxy

Ron Bauman

>I've had some success with other oily woods by soaking them for a while in lacquer thinner and after drying use epoxy. Try it on a scrap first, good luck.