Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Drive belt for PM 90 lathe

Posts

Drive belt for PM 90 lathe

#1

Drive belt for PM 90 lathe

Eddie Pacheco, San Jose, Ca.

>I have an old PM 90 lathe that I completed rewiring and now I can't remember where I left the drive belt. (CRS!) Does anyone here have a p/n for the dirve belt? Mine is the vintage 90 that has the motor mounted within the lathe bed. The s/n is 66-4819.

Thanks.

I'll also be visiting the OWM website.

Re: Drive belt for PM 90 lathe

#2

Re: Drive belt for PM 90 lathe

TomCollins

>Eddie,

If you don't have any luck coming up with a part number try beltsforanything.com If they don't have a way of looking up your model directly they will work with you to get one that will fit. I have found they have reasonable prices and cheap shipping

Tom

I have no affiliation with this company, blah, blah, blah........but I did get good service

Re: Drive belt for PM 90 lathe

#3

Re: Drive belt for PM 90 lathe

Ron Bauman

>Email Powermatic and ask them. I've had some success there. My 90 is still broken down and the belt is lying about somewhere. It's a 60's vintage and if its any help I can get you the serial nos. off it for you. Email me at fieldmouse@netwurx.net if you need it.

Re: Drive belt for PM 90 lathe

#4

Thanks, Tom, I'll give them a call today.

Eddie Pacheco; San Jose, Ca.

>

Re: Drive belt for PM 90 lathe

#5

I just e-mailed you and PM. Thanks, Ron.

Eddie Pacheco; San Jose, Ca.

>

Re: Drive belt for PM 90 lathe

#6

Powermatic service rocks!

Eddie Pacheco; San Jose, Ca.

>I got a reply to my drive belt info request in less than 1/2 an hour after sending them an e-mail.

Re: Drive belt for PM 90 lathe

#7

Re: Drive belt for PM 90 lathe

Philip Morris

>Eddie,

FWIW. Old Woodworking Machinery (www.owwm.com) has electronic copies of PM90 owners manuals and parts lists under their publications tab.

Re: Drive belt for PM 90 lathe

#8

Thanks, Phillip.

Eddie Pacheco; San Jose, Ca.

>That was the first place I went to and while I did find the p/n for the belt (90-257) it did not come up at the Powermatic site. I ended up ordering the belt based on the actual belt number that Powermatic gave me and it should be here tomorrow. I getting this lathe ready to sell as I'm real happy with the used PM3520 I purchased shortly after getting the 90.