Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Metal Fatigue

Posts

Metal Fatigue

#1

Metal Fatigue

Paul Zerjay

>How many times do you reuse the same screws in your faceplate turnings? Yesterday I was turning a big heavy blank of about 35 lbs. when it popped into my head that I have never changed screws in my faceplate. I use a soft start and soft stop method, but I would think that during the roughing stage, the screws would still take a pretty good beating. I would guess that I've been using the same screws for over three years. I think its time I change them out.

Re: Metal Fatigue

#2

I use them till I loose them

Cyril Griesbach

>

Re: Metal Fatigue

#3

Same here

Brian Hahn in SW Wisconsin

>They usually break when being removed - the wood has had time to really bond with the screw - leaving most of the screw in the wood. A real pain. I've never had one break while turning.

So many variables... It is hard to predict when they are going to fail... So I use them until they die.

Re: Metal Fatigue

#4

Re: Metal Fatigue

Ed Wujciak

>I use them till I damage the head enough so they're hard to drive and/or remove. Usually 5-20 uses or so....

Re: Metal Fatigue

#5

Re: Metal Fatigue

Sean Troy

>I change them every time. I use lags and buy them by the box, they are pretty cheap.

Re: Metal Fatigue

#6

Use them till the head wears out.

john lucas

>

Re: Metal Fatigue

#7

Square-drive heads last forever...

Brian Hahn in SW Wisconsin

>and so do the screws.

Re: Metal Fatigue

#8

Re: Square-drive heads last forever...

john lucas

>Mine don't last forever but they do outlast philips and flat heat about 10 to 0ne. I use hex head for my larger screws. Also if you have air get an impact wrench. It makes it so much easier to install the screws because it doesn't twist the turning out of your hand or off the workbench.

Re: Metal Fatigue

#9

Re: I use them till I loose them

Duane C.Leach

>Drill out the faceplate holes to 1/4". Use 1/4" hex head screws. Screws of any smaller size are not heavy enough to suport large wet bowl blanks.

Duane