Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Is anybody using the Worksharp on lathe tools?

Posts

Is anybody using the Worksharp on lathe tools?

#1

Is anybody using the Worksharp on lathe tools?

Mark in B'ham, AL

>I have tried sharpening my gouges with the slotted wheel. I am only using the course grit. I got some used tools in a box of stuff from my father that need a good bit of sharpening and reshaping.

Is anybody else using the WS3000? Are you progressing through grits? Do I need another slotted wheel?

Thanks, Mark

Re: Is anybody using the Worksharp on lathe tools?

#2

Re: Is anybody using the Worksharp on lathe tools?

Allen Neighbors

>Mark, I've never heard of it. Sounds interesting, though. Slotted wheels? So you can see the actual edge when sharpening? Must be a nifty tool... :)

I'll be watching this thread.

Re: Is anybody using the Worksharp on lathe tools?

#3

Worksharp review *LINK*

Mark in B'ham AL

>Allen:

There was a thread on the Message board back in November. Garrett had done a review of the system. He talks some about the slotted wheel. Here's the link.


Worksharp review thread

Re: Is anybody using the Worksharp on lathe tools?

#4

So, I'll take that as a "no" then.

Mark in B'ham, AL

>